Cristin-resultat-ID: 1271033
Sist endret: 24. september 2015, 19:36
Resultat
Vitenskapelig Kapittel/Artikkel/Konferanseartikkel
2008

Low Coherence Speckle Interferometry (LCSI) when speckle interferometry goes sub-surface

Bidragsytere:
  • Kay Gastinger

Bok

Eighth International Conference on Correlation Optics, Chernivtsi, Sept. 11-14, 2007
ISBN:
  • 9780819472182

Utgiver

SPIE--The International Society for Optical Engineering

Om resultatet

Vitenskapelig Kapittel/Artikkel/Konferanseartikkel
Publiseringsår: 2008
Hefte: 7008
ISBN:
  • 9780819472182

Importkilder

SINTEF AS-ID: S10488

Beskrivelse Beskrivelse

Tittel

Low Coherence Speckle Interferometry (LCSI) when speckle interferometry goes sub-surface

Sammendrag

In this paper the theoretical back-ground and basic principles of Low Coherence Speckle Interferometry (LCSI) are described. Furthermore the main parts of our research work are briefly introduced (1) the development of a dual wavelength. open-path LCSI setup (2) the introduction of a new method for the detection of zero path length difference for temporal phase shifting (3) the optimisation of the optical parameters of LCSI to increase the probing depth (beam ratio, position of the coherence layer and imaging parameters) (4) the fundamental understanding of the measurement effect and quantification of the measurements using a one-dimensional transmission line model. Finally, LCSI is introduced as a too] for characterisation of adhesion. In this work fundamental studies on interfacial instabilities in adhesive bonded aluminium joints are carried out. The basic hypothesis is that low adhesion is due to the existence of microscopic delaminations at the interface between the substrate and the adhesive. These delaminations can be caused by imperfect pre-treatment, surf, ace topography or other surface phenomena (e.g. corrosion. inter-metallic particles, etc.).

Bidragsytere

Kay Gastinger

  • Tilknyttet:
    Forfatter
    ved Smart Sensors and Microsystems ved SINTEF AS
1 - 1 av 1

Resultatet er en del av Resultatet er en del av

1 - 1 av 1