Cristin-resultat-ID: 1299109
Sist endret: 29. mars 2017, 17:08
NVI-rapporteringsår: 2015
Resultat
Vitenskapelig artikkel
2015

Design aspects on winding of an MgB2 superconducting generator coil

Bidragsytere:
  • Niklas Magnusson
  • J. C. Eliassen
  • A.B. Abrahamsen
  • Arne Nysveen
  • Jarle Bjerkli
  • Magne Runde
  • mfl.

Tidsskrift

Energy Procedia
ISSN 1876-6102
e-ISSN 1876-6102
NVI-nivå 0

Om resultatet

Vitenskapelig artikkel
Publiseringsår: 2015
Publisert online: 2015
Volum: 80
Sider: 56 - 62
Open Access

Importkilder

Scopus-ID: 2-s2.0-84969917077

Beskrivelse Beskrivelse

Tittel

Design aspects on winding of an MgB2 superconducting generator coil

Sammendrag

Generators based on superconducting rotor coils are considered for future large off-shore wind turbines for their low weight and compact design, and for their possibility to reduce costs. In the 10-20 K temperature range, MgB2 superconductors carry current densities 100 times higher than standard copper conductors at room temperature at one tenth of the wire cost per unit carried current. In the framework of the European project INNWIND.EU, an MgB2 superconducting generator pole will be designed, built and tested. Some of the design aspects of this work with emphasis on the winding process and associated coil insulation are discussed. An overall high current density in the coil is of crucial importance to obtain clear benefits compared to conventional solutions. The wire itself may be the most important parameter in that respect. However, the overall current density of the coil is also influenced by the thickness of the turn-to-turn electrical insulation. Here we discuss the impact of the insulation and suggest the use of a one-step winding process, employing wet-winding, where the applied epoxy also constitutes the insulation layer between turns. In this way the coil is densified by approximately 10% compared to the use of an additional, dedicated, electrical insulation like Kapton for wet-winding or glass-fibre for dry-winding followed by vacuum impregnation. We show the results of a trial winding of 500 m of MgB2 superconducting wire into a double pancake coil using the wet-winding technique. The coil is tested for contacts between the turns to evaluate the suggested one-step wet-winding process.

Bidragsytere

Niklas Magnusson

  • Tilknyttet:
    Forfatter
    ved Elkraftteknologi ved SINTEF Energi AS

J. C. Eliassen

  • Tilknyttet:
    Forfatter
    ved Institutt for elkraftteknikk ved Norges teknisk-naturvitenskapelige universitet

A.B. Abrahamsen

  • Tilknyttet:
    Forfatter
    ved Danmarks Tekniske Universitet
Aktiv cristin-person

Arne Nysveen

  • Tilknyttet:
    Forfatter
    ved Institutt for elkraftteknikk ved Norges teknisk-naturvitenskapelige universitet

Jarle Bjerkli

  • Tilknyttet:
    Forfatter
    ved Elkraftteknologi ved SINTEF Energi AS
1 - 5 av 7 | Neste | Siste »