Cristin-resultat-ID: 1912162
Sist endret: 20. februar 2023, 12:29
NVI-rapporteringsår: 2021
Resultat
Vitenskapelig artikkel
2021

Heat transfer characteristics of CO2 condensation on common heat exchanger materials: Method development and experimental results

Bidragsytere:
  • Ingrid Snustad
  • Åsmund Ervik
  • Anders Austegard
  • Amy Brunsvold
  • Jianying He og
  • Zhiliang Zhang

Tidsskrift

Experimental Thermal and Fluid Science
ISSN 0894-1777
e-ISSN 1879-2286
NVI-nivå 1

Om resultatet

Vitenskapelig artikkel
Publiseringsår: 2021
Publisert online: 2021
Trykket: 2021
Volum: 129
Artikkelnummer: 110440
Open Access

Importkilder

Scopus-ID: 2-s2.0-85108682695

Beskrivelse Beskrivelse

Tittel

Heat transfer characteristics of CO2 condensation on common heat exchanger materials: Method development and experimental results

Sammendrag

Understanding condensation of CO2 is essential for e.g designing compact heat exchangers or processes involved in Carbon Capture and Storage. However, a consistent experimental campaign for condensation of CO2 on common materials is lacking. In this work, we present an experimental method and an associated laboratory setup for measuring the heat transfer properties of CO2 condensation on materials commonly used in heat exchangers for the liquefaction of CO2. We have investigated the heat transfer during CO2 condensation on copper, aluminum, stainless steel (316) to reveal the heat transfer dependency on surface properties. The experiments are conducted at three saturation pressures, 10, 15, and 20 bar and at substrate subcooling between 0 and 5K. The results show that the heat transfer coefficients decrease with increasing surface subcooling. It was also found that increasing the saturation pressure increases the heat transfer coefficient. The results indicate that surface roughness and surface energy affect the condensation heat transfer coefficient, and an increased roughness results in reduced heat transfer coefficients. The highest heat transfer coefficient is found for condensation on copper, for which the lowest surface roughness has been measured.

Bidragsytere

Ingrid Snustad

  • Tilknyttet:
    Forfatter
    ved Institutt for konstruksjonsteknikk ved Norges teknisk-naturvitenskapelige universitet

Åsmund Ervik

  • Tilknyttet:
    Forfatter
    ved Gassteknologi ved SINTEF Energi AS

Anders Austegard

  • Tilknyttet:
    Forfatter
    ved Gassteknologi ved SINTEF Energi AS

Amy Brunsvold

  • Tilknyttet:
    Forfatter
    ved Gassteknologi ved SINTEF Energi AS

Jianying He

  • Tilknyttet:
    Forfatter
    ved Institutt for konstruksjonsteknikk ved Norges teknisk-naturvitenskapelige universitet
1 - 5 av 6 | Neste | Siste »