Cristin-resultat-ID: 1914370
Sist endret: 16. august 2021, 09:10
NVI-rapporteringsår: 2021
Resultat
Vitenskapelig artikkel
2021

Selective Vacuum Evaporation by the Control of the Chemistry of Gas Phase in Vacuum Refining of Si

Bidragsytere:
  • Arman Hoseinpur Kermani
  • Stefan Andersson
  • Kai Tang og
  • Jafar Safarian

Tidsskrift

Langmuir
ISSN 0743-7463
e-ISSN 1520-5827
NVI-nivå 1

Om resultatet

Vitenskapelig artikkel
Publiseringsår: 2021
Publisert online: 2021
Trykket: 2021
Volum: 37
Hefte: 24
Sider: 7473 - 7485
Open Access

Importkilder

Scopus-ID: 2-s2.0-85108506485

Beskrivelse Beskrivelse

Tittel

Selective Vacuum Evaporation by the Control of the Chemistry of Gas Phase in Vacuum Refining of Si

Sammendrag

The evaporation of P from liquid Si under vacuum and reduced pressures of H2, He, and Ar was studied to evaluate the feasibility of effective P removal with insignificant Si loss. It was found that the introduction of Ar and He inert gases at low pressures reduces the rate of P removal, and their pressure decrease will increase the process rate. Moreover, the kinetics of P removal was higher in He than in Ar, with simultaneous lower Si loss. Under reduced pressures of H2 gas, however, the P removal rate was higher than that under vacuum conditions with the lowest Si loss. Quantum chemistry and dynamics simulations were applied, and the results indicated that P can maintain its momentum for longer distances in H2 once it is evaporated from the melt surface and then can travel far away from the surface, while Si atoms lose their momentum in closer distances, yielding less net Si flux to the gas phase. Moreover, this distance is significantly increased with decreasing pressure for H2, He, and Ar gases; however, it is the largest for H2 and the lowest for Ar for a given pressure, while the temperature effect is insignificant. The rate of P evaporation was accelerated by applying an additional vacuum tube close to the melt surface for taking out the hot gas particles before they lose their temperature and velocity. It was shown that this technique contributes to the rate of process by preventing condensing gas stream back to the melt surface.

Bidragsytere

Arman Hoseinpur Kermani

  • Tilknyttet:
    Forfatter
    ved Institutt for materialteknologi ved Norges teknisk-naturvitenskapelige universitet

Stefan Andersson

  • Tilknyttet:
    Forfatter
    ved Metallproduksjon og prosessering ved SINTEF AS

Kai Tang

  • Tilknyttet:
    Forfatter
    ved Metallproduksjon og prosessering ved SINTEF AS

Jafar Safarian

  • Tilknyttet:
    Forfatter
    ved Institutt for materialteknologi ved Norges teknisk-naturvitenskapelige universitet
1 - 4 av 4